Peerless Tips About How To Build A Flamethrower Exhaust
Wire it so that when the switch is thrown, power.
How to build a flamethrower exhaust. 00:04:44 take this hose plug it into the tank and. Find the current coil of your car. The spark plug will be inserted into the exhaust tip with a drilled hole and a helicoil.
There are controllers available from speedway motors. After my video on my hot licks exhaust dual flamethrower kit on my 2016 indian 116 chieftain, i have been asked to make a video on how it is setup. Perfect for most cars, trucks, and motorcycles.
How i made a flamethrower exhaust for my classic bronco. Use an electric drill to make a small hole in the exhaust pipe, approximately 4 to 6 inches away from the rear of the pipe. Tools used in this project are:
Center punch (well, a nail, if you will) tap (matching the brass fitting. Mount the coil near the spark plug. On this episode of make it kustom, i show you step by step how to build a stand alone ignition system for a flame thrower exhaust for your “bbq” 😉 materials.
00:04:49 ignition and of course a. In this video, karl from make it kustom is going to build and install a complete setup for you to check out and then of course send some flames flying! Well this video does exactly that.
00:04:46 add a propane torch underneath the. My controller was made for me by a friend. At the bottom of the control panel, on the firewall, etc.